Glass Cutting Machine is a special equipment for cutting glass. Do you know what to pay attention to during the operation? Today jingling machinery will give you a brief introduction.

Matters needing attention:

1, there should be no scratching or white spots on the surface of glass.

2. In cutting a large number of glass, it is necessary to test the performance of the cutting machine. The testing method is to check the effect of the first piece of glass cut by the cutting machine.

3. Before moving the glass, we should check whether there are cracks in the glass itself. If there are cracks, we can be more careful when moving, or discard them directly, so as to avoid sudden rupture in the process of moving.

    The above tidied up operation methods and the matters needing attention in use, I hope that when you use the glass cutter, you must strictly follow the safety rules, and pay attention to the matters mentioned to ensure your personal safety.

Glass cutter

     Glass cutter is a kind of machine which is not very common in our life. Usually when we go to the glass market, we will see people using this machine to make the size and size you want. Linear edge grinder (straight edge grinder, circular edge grinder, bevel edge grinder) works by grinding glass through front and rear pressure plate clamping and driving its linear motion.

We must pay attention to two points when using:

    The joint of front and rear pressure plate and guide rail should be lubricated frequently, otherwise the normal service life of the machine will be affected by the premature wear of front and rear pressure plate and guide rail working face. Some models have automatic lubrication devices, but check the lubrication line regularly.

(2) When clamping the glass, the clamping force should be appropriate. Too loose will affect the grinding quality. Too tight will increase the load of the machine, easily produce the phenomenon of jitter and creep, and it is easy to break the glass when grinding thin glass. The clamping force can be tested on a machine by a slightly larger glass.

That is to say, the glass is clamped in the middle of the machine, and the glass is moved by the force plate of both hands when the machine is shut down. It is appropriate to adjust the clamping force to just when the two hands can not move.

The above is about the use of glass cutting machine linear edge grinding machine, hope to help you.