Glass cutting machine, as a person who knows the glass industry, this machine is not unfamiliar, but some people still do not know much about glass cutting machine, the next thing I say is that glass cutting opportunities to promote the glass in a certain angle. How did it proceed?

    Glass cutting machine. If the scratch of glass is caused by the tempering process, we should analyze it from the following aspects, check the drive roll, confirm whether there is foreign body on the ceramic roll, check the ceramic roll one by one, see if there is abnormal transmission of individual roll, slip phenomenon, or the phenomenon that a certain roll does not pass; observe the glass. When the glass and furnace enter the furnace, if the light sensitivity of the furnace door fails, the calculation of glass length will be wrong, then the glass will hit the furnace door when entering the furnace, causing all the transverse scratches on the glass surface. Check whether there is glass slag in the upper and lower wind grids of the cooling section. If there is glass slag in the upper and lower wind grids, it is easy to cause scratches on the glass surface.

    Working order. The whole glass can be shifted by crane or forklift truck. The movable glass frame by hand can also be used to minimize the number of glass shifts. The use of hand-pushed glass movable glass frame is limited to the flat ground condition inside the workshop, so as to reduce the vibration between the glass when pulling the glass frame. If you want to move glass, you must handle it carefully. First, the bottom of the glass touches the supporting beam at the bottom of the glass frame. When you put it, you should keep the glass at a certain distance from the front. Then, you should push the glass flat near the front. When you push it, you should push it flat as possible, then slide it to make the bottom of the glass. Each point of the edge contacts the glass placed in front at the same time, and can not push obliquely. The glass cutter makes the glass push at a certain angle, so it is easy to cause slender scratches on the glass.

   In addition, in order to change the sequence, we should increase the strength of mutual inspection between the processes, find scratches, deal with them in time, check one by one, find the root cause, deal with the scratched glass in time, and polish the sliced glass.